) 从输送带带尾向后，测量接头长度加允许修边长度的距离 FROM END OF BELT, MEASURE BACK LENGTH OF SPLICE PLUS TRIM ALLOWANCE.
b) 使用丁字尺划线USE SQUARE AND STRAIGHT EDGE TO DRAW MASTER LINE.
) 将丁字尺沿输送带对面的边放置，来检查主线。在每个边缘划分搭接长度，并检查两个对角线的长度是否相等。CHECK MASTER LINE BY LAYING SQUARE ALONG OPPOSITE EDGE. MARK OFF BIAS LENGTHS ON EACH EDGE AND CHECK THAT TWO DIAGONAL LENGTHS ARE EQUAL. 准备相对的带尾，向后折叠，重复上述工序，确保另一带尾上的斜线是在对边上。TO PREPARE OPPOSITE END, FOLD BELT BACK AND REPEAT PROCEDURE. MAKE SURE BIAS IS ON OPPOSITE EDGE ON OTHER END.
b) 使用丁字尺划线USE SQUARE AND STRAIGHT EDGE TO DRAW MASTER LINE.
) 将丁字尺沿输送带对面的边放置，来检查主线。在每个边缘划分搭接长度，并检查两个对角线的长度是否相等。CHECK MASTER LINE BY LAYING SQUARE ALONG OPPOSITE EDGE. MARK OFF BIAS LENGTHS ON EACH EDGE AND CHECK THAT TWO DIAGONAL LENGTHS ARE EQUAL. 准备相对的带尾，向后折叠，重复上述工序，确保另一带尾上的斜线是在对边上。TO PREPARE OPPOSITE END, FOLD BELT BACK AND REPEAT PROCEDURE. MAKE SURE BIAS IS ON OPPOSITE EDGE ON OTHER END.
郑重声明：资讯 【输送带丁字尺法的规划法】由 发布，版权归原作者及其所在单位，其原创性以及文中陈述文字和内容未经(企业库qiyeku.com)证实，请读者仅作参考，并请自行核实相关内容。若本文有侵犯到您的版权， 请你提供相关证明及申请并与我们联系（qiyeku # qq.com）或【在线投诉】，我们审核后将会尽快处理。
—— 相关资讯 ——
