Category:heavy

Question:
you master. there who knows how to be an ordinary point of a knife sharpener
grinding R, please pointing 12 ah
younger brother is now in great need of
hope that the wing

Answer:
I do not know what use you want to send.
common point of view Grinder. also known as the angle to the wheel can be held in the hand, can be polished using, of course, can also be grinding R knife, but very dimension mill, it is best taught (see) again, I say this I do not know can clear you want to use the wheel angle to the wheel, it is relatively thin, it is relatively small (Park Drive), you will the use of these two points, to grinding lathe tool or other tool of your. You can shun grinding. can also be counter-mill, single-handedly brought a knife (also available units clamp), one hand corner to the wheel, according to your R-orientation of grinding the disadvantage is that a little hand-shaking, a little danger, one safety, one piece may be raw not ideal.
I wish you every success.

Chinese:磨刀机的用法之一,做工模的请进

类别: 重工业

问题:
各位大师.有那位知道用普通的角度磨刀机
磨R刀,请指点一二啊
小弟现在很需要
希望不吝赐教

回答:
我不知道你要派什么用.
普通的角度磨刀机.又称角向砂轮,可拿在手上,可抛光用,当然也可磨R刀,不过很维磨,{zh0}有人教(看)一遍,我这样讲,不知道能不能清楚,你要利用角向砂轮的砂轮,它比较薄,它比较小(园径),你就利用这两点,去磨你的车刀或别的刀具.你可以顺磨.也可反磨,一手拿来刀(也可用台钳夹),一手拿角向砂轮,按你的R方向磨,缺点就是手有点抖,有点危险,一是安全,一是工件有可能被磨得不理想.
祝你成功.