传热 传质耦合

1. 发生在蔬菜干燥期的传递现象有限元分析A FEM Analysis of Transport Phenomena Occurring During Vegetables Drying
2. 核燃料棒中热和氧原子的扩散模拟Modeling heat and oxygen atom diffusion in nuclear fuel rods with FEMLAB
3. 烤肉过程中传热传质的初步模拟Thermal and Velocity Field Analysis Inside an Historical
Building - The Hall of Two Hundred Case Study
4. 煤燃烧过程中的传热、传质计算Computations on the coupled heat and mass transfer during fires in bulk materials, coal deposits and waste dumps
5. 热耗散Thermal Dissipation of DIMM Modules in Tower-BTX Configuration
6. 使用COMSOL模拟建筑中热、空气、水分传递HAM Construction modeling using COMSOL with MatLab Modeling Guide, version 1.0
7. 太阳能热水器分析Analysis of Solar Hot Water Storage
8. 头灯内冷凝的分析和测量 Automotive Headlamp - Analytic Solution and Measurements of Condensation inside a Headlamp
9. 油煎和冷却过程中的传质、传热现象的数学模型油煎和冷却过程中的传质、传热现象的数学模型 Numerical modeling of coupled heat and mass transport during frying and cooling of wood in contact with oil

电化学应用

1. 工业电解电池有限元模型FEM Modeling of an Industrial Scale Electrolysis Cell
2. 纳米尺度叉指形电极上扩散控制的氧化还原循环Diffusion-Controlled Redox Cycling at Nanoscale Interdigitated Electrodes
3. 微电极电化学电阻的FEMLAB数值模拟Numerical Simulation of the Electrochemical Impedance of a Microelectrode using FEMLAB
4. 微电极矩阵循环伏安法模拟Cyclic Voltammetry Simulation at Microelectrode Arrays
5. Modellierung von Dünnschichtzellen Thin Layer Flow Cell Modelling
6. Nafion-Polypropylene复合膜中的传递现象Transport Phenomena in Nafion®-Polypropylene Composite Membrane
7. 瘤的电化学xxElectrochemical Treatment of Tumors

电泳、电渗

1. Wicke-Kallenbach渗透电池中通过Zeolite膜的组分的完整传递模型A Complete Transport Model of Components through Zeolite Membranes in a Wicke-Kallenbach Permeation Cell
2. 交叉电极上的电子传递Effect of Electron Transfer Rate on the Electrochemical Process of Interdigitated Electrodes
3. 毛细管柱中电泳、传递现象Electrophoresis, Transport in a Capillary Column

反应动力学 热力学

1. COMSOL模拟非稳态条件下的催化反应Catalytic Reactions under Unsteady-State Conditions. Modelling with COMSOL
2. FEMLAB动力吸附：气体污染物通过活性炭吸附床的穿透曲线模拟Dynamic Adsorption with FEMLAB, Modeling breakthrough curves of gaseous pollutants through activated carbon beds
3. FEMLAB模拟NOx在NaZSM-5上的吸收Modeling NOx Adsorption on NaZSM-5 Film with FEMLAB
4. FEMLAB在高密度流超临界氢同位素反应堆冷源上应用Application of FEMLAB on Supercritical Hydrogen Components of the High Flux Isotope Reactor Cold Source
5. Simulationen als Werkzeug für die Designoptimierung von
6. Zur Kopplung zwischen Transport und chemischen Speziationsrechnungen mit FEMLAB®
7. 化学反应热传递和在含能材料中的气体扩散Laboratoire Energétique Explosions et Structures – Université d’Orléans IUT 63, avenue de Lattre de Tassigny
8. 两个对映体反应自由能区别研究
9. Simulation des Durchbruchsverhaltens in der Gas-phase气相反应模拟
10. 热固化聚合物纳米材料的化学和流变行为模拟Modelling of the Chemo–Rheological Behaviour of Thermosetting Polymer Nanocomposites

反应器设计 模拟

1. ARP碳热反应器的2D多物理场计算流体力学模拟2D Multiphysics CFD Modeling of an ARP Carbothermic Reactor
2. LTCC搅拌器-燃烧室模型Modeling of an LTCC Mixer /Combustor
3. 低NOx涡两喷燃器的分析和模拟Analysis and Modelling of a low NOx “Swirl Burner”
4. 低浓度甲烷在催化流向变换反应器中的燃烧Combustion of Lean Methane in a Catalytic Flow Reversal Reactor
5. 低压化学气相沉积的船型反应器Boat Reactor for Low Pressure Chemical Vapor Deposition
6. 非线性催化床反应器中的传热、传质模拟Modeling of Heat and Mass Transport in a Nonlinear Catalytic Bed Reactor
7. 金属有机物化学汽相淀积反应器模拟MOCVD Research Reactor Simulation
8. 空气湿度对VOC和建筑材料之间的相互关系的影响The influence of air humidity on the interaction between VOC and construction materials
9. 模拟LTCC混合器、燃烧器Modeling of an LTCC Mixer /Combustor
10. 喷流流化床的设计和仿真Design and Simulation of a Spout Fluid Bed Coating System

腐蚀现象

1. FEMLAB对碳钢流动加速腐蚀模拟的初步研究Flow Accelerated Corrosion Modelling of Carbon Steel Using FEMLAB : a Preliminary Study
2. Femlab裂隙腐蚀模拟的介绍Introduction to the modelling of crevice corrosion with Femlab
3. 不锈钢亚稳态孔蚀的计算机模拟研究Study of the metastable pitting of Stainless Steels by computer simulations
4. 数值模拟不同参数控制裂隙腐蚀影响的表征.Characterization of the influence of the different parameters controlling the propagation of crevice corrosion by numerical modeling
5. 通过有限元磨损模拟器 优化电化学测试设备Optimisation of the Electrochemical Instrumentation of a Wear Simulator through Finite Element Modelling.

化工中的流体计算

1. 薄流体膜通过圆筒的流动 The Flow of a Thin Liquid Film Past a Cylinder
2. 对流扩散方程的应用Solution of a Scalar Convection-Diffusion Equation Using
FEMLAB
3. 基于有限元的复杂流变学过程模拟Model Predictive Control of a complex rheological forming Process based on a Finite Element Model
4. 气体在减压稀释系统中混合过程的模拟 Comsol Modelling of the Gas Mixing Process in a Ripple Reducer for NPL’s Time Division Dilution System
5. 在微流体通道中多孔流Fluid Flow Past an Aperture in a Microfluidic Channel