美国XITRON公司授权力高仪器为其在华销售总代理及技术支持服务!华南地区联系人:吴R 13423449834;美国GE及PHILIPS公司指定测试品牌 BALLAST TEST SYSTEMS 2574R Ballast Analyzer
FeaturesDisplays all relevant ballast measurements on a single screen. Can completely test a ballast in significantly under one second. Fully automatic ballast start-up and tube striking detection and data logging. Results may be obtained either graphically (via front panel or printout) or numerically (via IEEE488 or RS 232 interface) with down to 1 ms time resolution. IEEE488 or RS 232 control of up to 4• external AC sources. Allows single user interface. High-speed operation with ballast input measured in 1/2 cycle periods; ballast outputs measured in 512 us periods. Wide bandwidth, ballast output frequencies of up to 2 MHz can be accurately measured. Every signal is monitored continuously with 12 bit 21 MHz sampling. Built-in printer interface enables a• comprehensive test report to be printed in a semi-automatic test environment, or for recording results in an engineering environment. Automatic test sequencing and complete comparison of measurements against limits, including the selection of different 1500 series load modules and engagement of 1500 series line switch modules. No computer or user software required. DescriptionXitron Ballast Analyzers have the speed and versatility to completely change the way ballasts and tubes are being tested. 主要特点 完全测试4管,4镇流器 电磁,电子或混合(即3KVHID)镇流器 同时测量全部管脚 测量灯丝预热,白热与管撞击数据 工作台或机架,单机或综合系统 保证开机后启动电流峰值与撞击数据测量 每秒计可多至2000个测量 测试镇流器可少于100毫秒 DC/50/60/100Hz电源电源或10KHz至2MHz输出 电源或10KHz至2MHz输出 用户自定界限可多至2500个测量 内置测试序列附负载开关 IEC6 另可提供电源与镇流器负载 规格参数 电源输入 电压 / 电流: 0.1% 功率: 0.15% 镇流器输出 电压 / 电流: 0.1%(电源);0.3%(50KHz);5%(1MHz) 功率: 0.15%(电源);0.5%(50KHz);10%(1MHz) 谐波:电源与镇流器输出谐波 取样:可高至2MS/s连续取样 图像结果:谐波柱状图表, 过往数据记录 (2秒-10天, 0.5%时间分辨率)
实体规格 电源输入: 80 -265v峰值自动选择 50/60/400Hz于100VA{zd0} 尺寸: (高 x 宽 x 深) 4-1/2 x 11-1/2 x 10-1/2 重量: 2574: 操作范围: 0 °C - 储存范围: -30 °C -65 °C <95%相对湿度于 数字接口 (标准):IEEE488.1全话/听与控制器能力 平行: IEEE1284, 非格式化文字或PCL 镇流器负载 电阻值: 每管或灯丝可多至4个 管的数目: 每机架可多至4个 开路电平: < 15PF, > 镇流器输出电压: 可高至5KV 电源来源 开机后启动电流: 驱动功率: 可高至1500VA连续 ( 任何功率因素 ) 交流 / 直接产生: >300V均方根值 保修期:两年 订购资料 工作台型号 2或4脚负载 2脚负载 1管 2571 2571QS 2管 2572 2572QS 3管 2573 2573QS 4管 2574 2574QS 机架型号 1管 2571 2571QSR 2管 2572 2572QSR 3管 2573 2573QS 4管 2574 2574QS 特别声明:本网站上所提供的技术参数仅供参考,产品最终参数以产品说明书为准! |