Drum assembly line due to various reasons, after a long time of use more or less will occur some failures, drum assembly line manufacturer Qin Ai suggested that in the process of using the drum assembly line to do frequent observation, frequent maintenance. The common failures of drum assembly line are as follows:

Drum assembly line manufacturers how to solve the problem of power drum assembly line failure

The use of a power drum line is the most frightening situation, but every power drum line is very normal. * As if everyone gets sick, catches a cold, or has a fever, the machine * has a condition that proves it is not being operated improperly, that it has been working long hours, or that the power drum assembly line is old and should be updated. Now the editor will tell you why the power drum line is broken. There are many reasons, and we'll find some common ones.


First of all, see if it is the problem of the equipment itself, also is the reducer high speed shaft design strength is not enough, in this case, the general situation will occur outside the shaft shoulder. This place is often damaged by fatigue because it has a transition rounded corner. If the rounded corner of this place is too small, the bearing is easy to break the shaft, so we must pay attention to this place when choosing and buying. The power roller conveyor belt should pay attention to these subtleties.


Secondly, when the phenomenon of shaft fracture occurs, we should also check whether the high-speed axis is concentric. Because if the motor shaft and the speed reducer shaft are not in the same heart, then the speed reducer shaft * will be overloaded, so broken shaft is very normal. At this point, we must increase the bending moment along the axis. Therefore, this requires that when we install these things, we must have a good check, we must adjust our position to ensure that we have a heart and a heart, and after maintenance, we cannot ignore this problem. The installation and maintenance of the power drum line should be done well, otherwise it will greatly increase the cost and reduce the profit.


* After, if the use of double motor drive, will also cause the phenomenon of shaft fracture. This means that with two motors mounted on the same drum to drive the shaft, two retarders are more likely to damage the shaft because sometimes the range of choices is too small and the power drum line * will break the shaft.


Related labels: drum assembly line manufacturer http://www.kaizheng.com/